676
Engine ECM Internal Error
Engine ECM internal error
Engine ECM ride by wire internal error
5V Sensor Circuit A - reference
voltage low
View and note diagnostic software
'freeze-frame' data if available.
Disconnect engine ECM and proceed
to pinpoint test 1:
5V Sensor Circuit A-reference voltage
high
5V Sensor Circuit A - reference
voltage out of range
Check cable and terminal integrity:
- Engine ECM pin A32
- Engine ECM pin A20
Disconnect sensor and
proceed to test 2
Rectify fault, proceed to
test 5
Check cable for short circuit:
- Engine ECM pin A32 to ground
- Engine ECM pin A32 to Engine ECM
pin A20
Locate and rectify wiring
fault, proceed to test 5
Check cable for short circuit:
- Engine ECM pin A32 to Engine ECM
pin A08
- Engine ECM pin A32 to Engine ECM
pin A21
Locate and rectify wiring
fault, proceed to test 5