Triumph Rocket 3 GT 2021 - Page 736

698
Cornering Traction Control and Roll Over Detection Disabled
Fault
Code
Possible cause
Action
P1136
Cornering Traction Control disabled
due to Inertial Measurement Unit
(IMU) malfunction
View and note 'freeze-frame' data if
available.
Make sure ABS modulator connector
is secure.
Check for associated DTC C1713,
perform tests for this DTC. Reset
DTCs, if problem persists contact
Triumph service.
P16A2
Engine ECM detects IMU present but
with signal error
P1640
Roll Over detection disabled due to
Inertial Measurement Unit (IMU)
malfunction
View and note 'freeze-frame' data if
available.
Make sure ABS modulator connector
is secure.
Check for associated DTCs P16A0,
P16A1, and P16A2, perform the tests
for any DTC present.
Reset DTCs, if problem persists
contact Triumph service.
Closed Throttle Position Adaption
Fault
Code
Possible cause
Action
P16B0
Fully closed throttle position adaption
incomplete or unsuccessful
View and note 'freeze-frame' data if
available.
View and note diagnostic software
'sensor' data.
Check the throttle body for any
mechanical restrictions.
Make sure throttle position sensor
connector is secure.
Disconnect engine ECM and proceed
to pinpoint test 1: