732
LO006 - Rear Wheel Unit Sensor Loss of Communication
Refer to the owner's handbook for the wheel pressure sensors ID numbers.
Rear wheel sensor unit loss
of communication error
Low battery voltage
Wrong sensor ID number
has been registered in the
immobiliser/TPMS control
module
If the problem persists:
Using the Triumph diagnostic tool, check that
the correct ID number for the front wheel
pressure sensor is registered to the
Immobiliser/TPMS control module.
Replace the rear wheel pressure sensor
following the procedure described in the
Triumph diagnostic tool user guide.
Record the new sensor's ID number into the
owner handbook before fitting.
LO007 - Immobiliser/TPMS Control Module Fault
Refer to the owner's handbook for the wheel pressure sensors ID numbers.
Immobiliser/TPMS control
module fault
Low battery voltage
Wrong sensor ID numbers
have been registered in the
immobiliser/TPMS control
module
Using the Triumph diagnostic tool, check that
the correct ID numbers for the wheel pressure
sensors are registered to the
Immobiliser/TPMS control module.
If the correct IDs are registered, replace the
front and rear wheel pressure sensor following
the procedure described in the Triumph
diagnostic tool user guide.
Record the new sensor's ID number into the
owner handbook before fitting.
To Next Page
Loading...
