Triumph Rocket 3 GT 2021 - Page 824

786
2. Detach the solenoid from the evaporative canister bracket.
3. Using service tool T3880207 release the clamp and detach the secondary air injection
hose from the solenoid.
4. Disconnect the electrical connector and remove the secondary air injection solenoid.
1. Purge valve
2. Evaporative canister bracket
3. Clamp
4. Electrical connector
Secondary Air Injection Solenoid - Installation
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.