869
3. Refit the coolant pressure cap.
4. Start the motorcycle and allow the engine to idle. Briefly raise the engine speed
several times to allow any air to be expelled from the system.
5. Stop the engine and allow it to cool.
6. Remove the coolant pressure cap.
7. If necessary, top up the system through the filler.
8. Fit the coolant pressure cap to the radiator filler neck and tighten the fixing to 1 Nm.
9. Align the alignment mark on the radiator cap cover to alignment mark on the
radiator cowl and it the radiator cap cover. Turn the cap cover clockwise to secure.
1. Fixing
2. Alignment mark
To Next Page
Loading...
