Triumph Rocket 3 GT 2021 - Page 951

913
NOTICE
Keep the torque wrench at 90 degrees to the centre line of the tool when you tighten
the adjustment nut in the stage that follows. This will apply the correct torque to the
adjustment nut.
NOTICE
The adjustment nut can turn up to 90 degrees when you tighten it anticlockwise. This
is usual.
• Using service tool T3880750 turn the adjuster nut anticlockwise 45°.
• Use service tool T3880750 to tighten the adjustment nut in an anticlockwise
direction to 65 Nm. Keep the torque wrench at 90 degrees to the centre line of
the tool.
1. T3880750 - Headstock Service Tool
2. Torque wrench
• Check that alignment marks on the adjuster nut and lock nut are no longer
aligned.