17
CONSOLE FUNCTIONS
RECOVERY
1. The RECOVERY key will only be valid if pulse is detected.
2. TIME will show “0:60” (seconds) and counts down to 0. Console will show F1 to F6 after the countdown |
to test heart rate recovery status. User can nd the heart rate recovery level based on the chart below.
3. Press RECOVERY key again to return to the beginning.
BODY FAT
1. ress the BODY FAT key to start body fat measurement
2. During measuring, users have to hold both hands on the hand grips. LCD display “-” “- -” “- - -” “- - - -” for
8 seconds until computer nish measuring.
3. LCD will display BMI and FAT %.
4. Error message:
*E-1–There is no heart rate signal input detected.
*E-4–Occurs when FAT% and BMI result is below 5 or exceeds 50.
TROUBLE SHOOTING:
• When the display of LCD is dim, it means the batteries need to be changed.
•
If there is no signal when you pedal, please check if the cable is well connected
NOTE:
1. When you stop training for 4 minutes, the main screen will switch off
2. If the computer displays abnormally, please re-install the batteries and try again.
F1 Outstanding
F2 Excellent
F3 Good
F4 Fair
F5 Below Average
F6 Poor
#20M03T008 OMEGA 390 STATIONARY BIKE USER MANUAL.indd 17 2020/03/25 3:59 PM
To Next Page
Loading...
