Trojan POWER GYM 1.0 - Step 5: Upper Cross Beam and Leg Assembly; Step 6: Cushions and Foam Rollers

13
POWER GYM 1.0
STEP 5
STEP 5:
Attach the Upper Cross Beam (9) to the Weight Guide
Tubes (3) using 2 Bolts (72).
Attach the Upper Cross Beam (9) to the Support
Frame (8) using 2 Hex Bolts (58), 4 Washers (67) and
2 Nylon Nuts (70).
Proceed to attach the Leg Extension Frame (6) and
the Seat Base Frame (7) by using 1 Hex Bolt (58), 2
Washers (67) and 1 Nylon Nut (70).
Ensure all bolts are tight before proceeding.
STEP 6:
Attach the Back Cushion (14) to the Support Frame
(8) using 2 Hex Bolts (62) and 2 Washers (68).
Now attach the Seat Cushion (13) to the Seat Base
Frame (7) using 4 Hex Bolts (65) and 4 Washers (68).
Insert the Foam Tube (17) into the Leg Extension
Frame (6) and the Seat Base Frame (7).
Ensure all bolts are tight before proceeding.
Slide the Leg Foam Rollers (30) onto the Foam
Tubes (17).
Leg length is different, up and down
adjustment Foam Tube(17) can adjust to the
appropriate position.
ASSEMBLY STEPS
STEP 6
8
58
67
67
70
9
72
3
67
70
67
58
7
6
Step5
17
17
30
30
30
30
13
14
8
68
62
68
62
7
65
68
Step6
#19M02T008 Power Gym 1.0 UM VERSION 4.indd 13 29/05/2019 13:29