Trojan POWER RACK 400 - STEP 3; STEP 4

10148-10
4. ASSEMBLY STEPS - CAGE
STEP 3
• AttachtheUprightFrame(5)andtheBackBase 
Tube (2) to the Connect Frame (20) using two
 3/8”x3-1/8”HexBolts(61),four3/8”Washers 
 (64)andtwo3/8”Locknuts(67).
STEP4
• AttachtheBackBeam(6)totheBackBaseTube 
 (2)usingtwo3/8”x3/4”HexBolts(54)andtwo
 3/8”Washers(64).
• InstalltwoSpringClips(35)totheSlideFrame 
(21), then slide the Slide Frame (21) onto the
 BackBeam(6).