ASSEMBLY STEPS
INSTRUCTIONS FOR ASSEMBLY
• Unpack the carton and using the parts list, check that all parts are accounted for.
• Do not dispose of the packaging material until assembly is complete.
• Tools are provided for assembly.
STEP 1: FRONT AND REAR STABILISERS INSTALLATIONS
• Attach the Front Stabiliser (6) onto the front curve of the Main Frame (1) with two M8 x 65 Bolts (35),
two Ф8 x Ф16 x 1.5 Arc Washers (36) and two M8 Cap Nuts (34). Tighten cap nuts with the Multi Hex
Tool with Phillips Screwdriver provided.
• Attach the Rear Stabiliser (4) onto the front curve of the Main Frame (1) with two M8 x 65 Bolts (35),
two Ф8 x Ф16 x 1.5 Arc Washers (36) and two M8 Cap Nuts (34). Tighten cap nuts with the Multi Hex
Tool with Phillips Screwdriver provided.
STEP 2: LEFT AND RIGHT FOOT PEDALS INSTALLATION
• The Cranks, Pedal Shafts, and Foot Pedals are marked “R” for Right and “L” for Left.
• Insert pedal shaft of Left Foot Pedal (20) into threaded hole in the left crank. Turn the pedal shaft by hand
in counter-clockwise direction until snug.
Note: DO NOT turn the pedal shaft in the clockwise direction, doing so will strip the threads.
• Tighten the pedal shaft of Left Foot Pedal (20) with the Multi Hex Tool with Phillips Screwdriver provided.
• Insert pedal shaft of Right Foot Pedal (21) into threaded hole in right crank. Turn the pedal shaft by hand
in a clockwise direction until snug. Tighten the pedal shaft of Right Foot Pedal (21) with the Multi Hex Tool
with Phillips Screwdriver provided.
STEP 1 & 2
TOOL:
Multi Hex Tool with Phillips
Screwdriver (S13, S14, S15)
To Next Page
Loading...
