Models: 08-4049C0013
08-4049-0013-A2, 08-4049-0013-A6, 08-4049-0013-A7
Engine Compressor Washer
11/2023 | Rev. 02 Page | 2
This product can not be modified without the written approval of Tronair, Inc. Any modifications done without written approval
voids all warranties and releases Tronair, Inc., it suppliers, distributors, employees, or financial institutions from any liability
from consequences that may occur. Only Tronair OEM replacement parts shall be used.
1.0 PRODUCT INFORMATION
1.1 DESCRIPTION
The Engine Compressor Washer is a portable unit designed to spray either cleaning solution and/or clean fresh
water into jet and turboprop engines.
The two fluid tanks will hold 12 gallons each. The air tanks, when charged to 125 psi, provide sufficient volume to
empty both fluid tanks. The nozzle mounted on the panel may be installed on the wand to regulate the fluid flow to
the approximate rate as indicated.
1.2 MODEL & SERIAL NUMBER
Reference nameplate on unit
1.3 MANUFACTURER
TRONAIR, Inc. Telephone: (419) 866-6301 or 800-426-6301
1 Air Cargo Pkwy East Fax: (419) 867-0634
Swanton, Ohio 43558 USA E-mail: sales@tronair.com
Website: www.tronair.com
2.0 SAFETY INFORMATION
2.1 USAGE AND SAFETY INFORMATION
To insure safe operations please read the following statements and understand their meaning. Also refer to your
equipment manufacturer’s manual for other important safety information. This manual contains safety precautions
which are explained below. Please read carefully.
WARNING! — Warning is used to indicate the presence of a hazard that can cause severe personal injury,
death, or substantial property damage if the warning notice is ignored.
CAUTION! — Caution is used to indicate the presence of a hazard that will or can cause minor personal injury
or property damage if the caution notice is ignored.
3.0 TRAINING
3.1 TRAINING REQUIREMENTS
The employer of the operator is responsible for providing a training program sufficient for the safe operation of the
engine compressor washer.
3.2 TRAINING PROGRAM
The employer provided operator training program should cover safety procedures concerning use of the engine
compressor washer in and around the intended aircraft at the intended aircraft servicing location.
3.3 OPERATOR TRAINING
The operator training should provide the required training for safe operation of the engine compressor washer.
NOTE: Maintenance and Trouble Shooting are to be performed by a skilled and trained technician.
To Next Page
Loading...
