Tronsmart Encore S2 Plus - Page 4

Play/Pause
Volume +/-
Previous/
Next track
Answering
a call
Rejecting a call
Ending a call
Redialing the
last called-out
number
Power On
Pairing mode
2
FUNCTIONS
Hold the multifunction button for 4 seconds till the red
indicator light flashes 1 second and then goes off.
Note: The headphones will automatically turn off if there is no
connection with any device within 5 minutes.
Tap the multifunction button once to play or pause the song.
Tap ‘V+’ button to turn up the volume.
Tap ‘V-‘ button to turn down the volume.
You will hear a voice prompt when it is at the maximum or
minimum volume level.
Previous track: Hold the ‘V-’ button for 1 second.
Next track: Hold the ‘V+’ button for 1 second.
Tap the multifunction button once to answer the call. Switch
the answering modes between Bluetooth and mobile phone
via holding the multifunction button for 1 second.
Tap the multifunction button once.
Double tap the multifunction button to dial the last call-out
phone number.
Hold the multifunction button for 2 seconds till the blue
indicator light goes on.
1. First use: Turn on the headphones, the red and blue lights
will flash alternately. Scan ‘Tronsmart Encore S2 Plus’ on your
Bluetooth device and tap to pair.
2. Re-pair: Power on the headphones, it will re-pair the device
that you pair with last time.
3. Bluetooth disconnect: Press the ‘V+’ and ‘V-’ button
simultaneously to disconnect the Bluetooth.
Power Off
Hold the multifunction button for 1 second to reject the call.
Microphone
muting
Standby mode
Low battery
Hold the ‘V-’ button for 1 second to mute the microphone.
There is a voice prompt every 10 seconds. Hold the ‘V-’ for 1
second, it will work again.
There will be a voice prompt every 60s with the red light
flashes twice.
Under pairing mode, if there is no device to pair with, the
headset will go to standby mode and power off after 5
minutes.