MiniMD Quick Start Guide
FIRST Watch the DVD or Online Videos for detailed How-To Instructions
The MicrodermMD is simple and easy to use with just a little bit of practice.
It takes only 5 minutes to get back that smooth, glowing, and youthful looking
skin that is just below the surface!
Register your Warranty today by visiting www.trophyskin.com/warranty
REV 07/2014
BEFORE TREATMENT
1
Wash and dry your face
before starting each
treatment.
2
Plug power adaptor
into wall power outlet.
Check to see the LED light
has come on
the power adaptor.
3
Press and HOLD
the power button
“ ”. The device will
turn on, and the
button/power level
light will light up.
4
Press the power button
again to adjust the suction
level to High.
We recommend starting
with Low Suction Level
for at least the first few uses.
5
With the suction motor
running, stroke the diamond
tip against the area of skin
to be treated.
It helps to pull the skin
tight or taut with your
free hand, especially in
hard to treat areas
6
Stroke the diamond tip
against the skin with
smooth, even motions,
making sure not to
stroke more than 2-3 times
in any given area.
7
Treat areas such as the face, neck, chest, arms, hands, feet, or
any other body area 2-3 times per week using this method.
If it feels comfortable to you, use the higher power level for
these other body areas.Treat areas such as the face, neck,
chest, arms, hands, feet, or any other body area 2-3 times per
week using this method. If it feels comfortable to you,
use the higher power level for these other body areas.
To Next Page
Need help?
General
