3
Square Fire Pit Base
Trim Detail
Locate the (4) brackets along the inner edges of the Riser. Place
the Fire Pit on to the Riser brackets so that the holes on the brackets
are aligned with the hole on the legs of the Fire Pit. Also take care
to align the trim detail on the Fire Pit with the trim detail on the Riser.
Once the Riser is fully aligned, place a lock washer on to a screw.
Loosely install the screw assembly through the underside of the
Riser bracket into the screw hole on the Fire Pit leg. Do not fully
tighten at this point. Repeat until all (4) screw assemblies are
installed and then fully tighten all screws.
Return Fire Pit with installed Fire Pit Riser to the upright position.
Install propane gas tank or attach natural gas connection.
4
Tropitone Furniture Co., Inc.
5 Marconi, Irvine, CA 92618
949 951 2010 phone
www.tropitone.com
For our current warranty and
product care information, please visit
www.tropitone.com / warranty
Part # R9T00023
©2015 Tropitone Furniture Co., Inc.
12/15
To Previous Page
Loading...
