Trotec PGGS 10-3,7V User Manual

9 EN
Operating manual – cordless glue gun PGGS 10-3,7V
Automatic switch-off
The automatic switch-off after 10minutes helps you to save
energy during work breaks. Only switch on the device when you
actually use it.
1. Switch the device back on using the on/off switch(2) and
check the status LED or the battery level indication to see
whether the device needs to be charged or heated up.
Gluing
Warning of hot surface
The nozzle might still be hot after use. Glue coming out
of the nozzle can be hot. Risk of burns.
Do not touch the nozzle bare-handed!
Wear protective gloves!
Info
When further glue sticks are pushed in, the device
requires a little more time for heating up than during
initial use. Hardened glue residues can block the feed
channel.
Info
The surfaces to be glued must be clean, dry and free of
grease.
The status LED is illuminated in green.
1. Allow the glue gun to heat up. Push a glue stick suitable for
the material into the feed channel(9) from the rear. Pull the
feed trigger(5) to control the flow of glue for the intended
task.
5
9
2. Apply the glue in dots or lines.
3. Immediately press the two workpieces to be bonded
together for approx.30seconds.
ð After approx.5minutes the glue joint will be able to
withstand loads.
4. During work breaks, put the device into the charger.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
• Switch off the device.
• Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
• If required, allow the device to cool down.
• Clean the device according to the Maintenance chapter.
• Store the device according to the Storage chapter.

Trotec PGGS 10-3,7V Specifications

General

Brand	Trotec
Model	PGGS 10-3, 7V
Category	Glue Gun
Language	English