6
Setup
CalibrationRelay
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
START
EXIT
BR1032A005b
© 2016 OJ Electronics A/S
Fig. 1 Menu scheme
Out
Return to parent menu [ ]
Factory reset
Confirm by selecting [ ].
Select [ ] to go back to menu [ ]
Zero pressure calibration
Confirm by selecting [ ].
Select [ ] to go back to menu [ ]
Out
Return to parent menu [ ]
Invert LED
[ ] Value < Setpoint => Green, [ ] Value < Setpoint => Red
Invert relay
[ ] normal output state, [ ] Inverted output state
Hysteresis
[01 - 50 % of maximum setpoint]
Relay activation delay
[0000 - 3600 Sec.]
Out
Return to parent menu [ ]
Analog output type
[0 - 10V / 0 - 20mA / 2-10V / 4-20mA]
Damping
[01 - 30 sec.]
Flow setpoint
[0.000 - 9999]
First set the dot possition, then set the value
Flow range
[0.000 - 9999]
First set the dot position, then set the value
k-factor
[0.001 - 9999]
First set the dot position, then set the value
Pressure setpoint
[0000 - 2500 Pa]
Pressure range
[0010 - 2500 Pa]
Pressure / flow mode
(Pressure Pa); (Flow)
Out
Leave the menu
BR1032A005b
To Next Page
Loading...