A
A
u
u
t
t
o
o
-
-
S
S
t
t
o
o
r
r
e
e
The Auto-Store function automatically stores sample data upon
completion of a measurement. The data is stored under the
active project, using a sequential sample ID number. When a
new project is created, the sample ID number for the Auto-Store
function starts at 1 and is incremented each time a new
measurement is stored automatically or manually.
To access the Auto-Store function, press 〈8〉 at the Projects menu
shown on page 8–2. The gauge requests an access code (see the
front of this manual). After entering the code, the gauge
displays:
To return to the Projects menu without changing the
Auto-Store status, press 〈ESC〉.
To turn the Auto-Store function on, press 〈1〉.
To turn the Auto-Store function off, press 〈2〉. The gauge
updates the Auto-Store status, displays a brief
confirmation message, and returns to the Projects menu.
Active Project Selected
If you attempt to enable the Auto-Store function and a project
has been selected as active, the gauge enables the Auto-Store
function, briefly displays the confirmation message shown
below, and then returns to the Projects menu.
Auto-Storage: OFF
1. ON
2. OFF
Press # to Select
Auto-Storage
Is Now ON
Prj: XXX
Next Sample # X
To Next Page
Loading...
