Troxler EGauge 4590 - Page 135

Model 4590
A-7
Error Message Possible Causes Solution
Depth Sensor
A hardware problem has
Enable Manual
depth mode. Contact 877-
TROXLER and press “2” and
TroxTechSupport@troxlerlab
s.com
Error. Enable
occurred with the depth
Manual Mode
strip.
Initialization Error
System is unable to
initialize. Another
gauge or nuclear
source nearby.
Vertical surface too
close. Must be at
least 6 feet away.
Insufficient warm-up
time.
This occurs if the source
rod is not in the SAFE
position during
initialization. If the error
continues to show in the
SAFE position, contact the
Troxler Service Center.
Error Writing to
An error occurred when
Try to store the data again.
the File
attempting to store data
If error recurs, try a
to a USB storage device.
different USB storage
device.
Error! Stat Test
Not Valid
Operator has tried to run
a drift test without
having a valid stat test.
Perform a stat test, and
then run a drift test.
Gauge Requires
Re-calibration!
The calibration constants
stored in the gauge have
become corrupted.
Contact the Troxler Service
Center.
Contact Tech
Support
Invalid Access
Code
Operator entered an
invalid access code.
Enter the correct access
code (see the front of this
manual).
Invalid Depth
The source rod is not at a
valid depth when starting
a measurement.
Ensure the source rod
position is at a valid depth
when starting a
measurement. Contact the
Troxler Service Center.