Troxler EGauge 4590 - Turning the Gauge on

Model 4590
3–7
T
T
u
u
r
r
n
n
i
i
n
n
g
g
t
t
h
h
e
e
G
G
a
a
u
u
g
g
e
e
O
O
n
n
NOTE
Charge the batteries for three to four hours prior to
initial use.
The gauge uses rechargeable NiMH batteries as a power source.
Press the power switch to turn the gauge to the on position.
When powered on the display screen fills with test characters
before proceeding to the two-second self-test phase.
Afterwards, the gauge enters a 300-second warm-up period.
During the warm-up period, the gauge displays the gauge model
number, software version, serial number, company name (if
programmed), and progress (in seconds) of the warm-up.
After the self-test, press any key to enter the Ready mode.
The gauge returns to the Ready mode when the gauge is ready to
proceed to another menu. The screen displays:
NOTE
The symbol in the upper right of the display
indicates that the Bluetooth is enabled and connected
to the Moisture probe or other Bluetooth device.
The symbol in the upper right of the display
indicates that the GPS is enabled.
-READY-
01-01-2014 12:21 PM
Prj: TROXLER
Press <START>
-Model 4590-
Battery xx Volts xx
Vx.xx SN: xxx