Tru-Test XRS2 Service Manual

XRS2 and SRS2 EID Stick Reader
Issue 5, 03/2018
13
Scanning problems
Symptom
Cause
Solution
Both models:
The stick reader only
scans an EID tag for
a short time.
Read Mode has been set to
Standard or Single modes.
This is normal operation for
Standard and Single read
modes.
In Standard and Single read modes, the stick
reader will stop scanning after 3 seconds if no tag is
read (unless the user holds the Scan key).
Alternatively the user can set the Read Mode to
Continuous mode. In this mode the stick reader
starts scanning when the Scan button is pressed and
keeps scanning until the Scan button is pressed
again.
To change the Read Mode, go to Home  Settings
 Tag Reading.
Both models:
The stick reader
keeps on scanning
for a tag
continuously unless
the Read button is
pressed again.
Read Mode has been set to
Continuous. This is normal
operation for Continous read
mode.
Alternatively the user can set the Read Mode to
either Standard or Single read modes.
In Standard mode, the stick reader begins scanning
when the Read button is pressed. Scanning continues
for 3 seconds or until a tag is read if this is sooner. If
the Read button is held down continuously, the stick
reader will continue to scan and therefore read
multiple tags. ‘Standard’ is the recommended
setting for general use.
In Single mode, the stick reader behaves as it would
in Standard mode. However, even if the Read
button is held down, the stick reader won’t continue
scanning after it reads the first tag. To scan another
tag, the Read button must be released and pressed
again.
To change the Read Mode, go to the Home 
Settings  Tag Reading.
Both models:
The stick reader only
scans one tag, even
though the Read
button is held down
continuously.
Read Mode has been set to
Single. This is normal
operation for Single read
mode.
In Single read mode, the stick reader will only read
the first scanned tag, even if the Read button is held
down continuously. To scan for another tag, the Read
button must be released and pressed again.
To change the way the stick reader scans an EID tag,
change the Read Mode to Standard or
Continuous.
In Standard mode, the stick reader begins scanning

Tru-Test XRS2 Specifications

General

Brand	Tru-Test
Model	XRS2
Category	Data Loggers
Language	English