CAUTION: STEAM AND DROPLETS
EMITTING FROM THE DEVICE ARE VERY
HOT. BE CAREFUL WHEN REMOVING
ATTACHMENTS & ACCESSORIES.
NOTE: Please Power OFF and unplug the unit
before performing the following steps
3. To attach any additional
accessory, align the small
arrow indicator on that piece
with the small arrow indicator
on the main adapter nozzle.
Then turn that accessory
clockwise to lock it into place.
4. To begin cleaning, power on
the device and wait for the
LED indicator to turn blue.
Once the device is ready,
press/hold trigger button
located under the handle and
the steaming process will
start. To stop, release the
trigger button.
5. If you'd like to change the
accessory attachment during
any stage of cleaning, please
wait 6 minutes until the
accessory attachment and main
adapter has cooled down.
Detach the handle and
mop head by pressing the
circle release buttons and
gently pulling the parts
apart.
1.
INSTRUCTIONS FOR USE: HAND HELD STEAMER
HAND HELD STEAMER
2. Attach the main adapter
nozzle (Pg.4, Part N) and make
sure that the circle release
button securely locks into place.
To Next Page
Loading...
Need help?
General
