MonoControlInstallation and connection
22 EN
50020-00990 ∙ 00 ∙ 08/2022
Install the gas pressure regulator in a suitable place�
Install the gas filter if necessary (see the instructions for the gas
filter)�
Screw the gas pipe onto the gas pressure regulator on the outlet
side using the 8mm or 10mm(H�9) cutting ring screw connec-
tion�
Screw the high-pressure hose onto the gas pressure regulator or
gas filter using the M20x1�5 (G�13) male thread on the inlet side�
2
1
Fig� 3
1 Connection for gas pipe
2 Connection for high-pressure hose or gas filter
4.5 Final steps
Check all the unions in the high-pressure section with a leak-fin-
der spray in accordance with EN14291 to ensure they are tight
(also see the operating instructions)�
After installation, have the entire gas system checked for leaks by
an expert in liquid gas (also see the operating instructions)�
After installation, have the entire gas system checked for leaks
and for proper installation and function by an expert in liquid gas�
If there is a gas testing certificate, this must be supplemented
or changed accordingly� This test does not replace the regularly
scheduled gas check�
To Next Page
Loading...
