GXT 580 Racing Wheel – USER’S MANUAL
- USER’S MANUAL
3. Steering Sensitivity
Press SELECT + START simultaneously for 3 seconds green LED turns on.
Press SELECT to see the current sensitivity.
Press SELECT again to cycle through the sensitivity levels.
Press D-Pad ↑ to confirm the sensitivity level.
Sensitivity level; Low = Green LED flashes slowly.
Sensitivity level; Middle = Green LED flashes.
Sensitivity level; high = Green LED flashes fast.
4. Button Relocation
The L-Pedal, R-Pedal, L3 and R3 can be programmed as X, Y, A, B, L1, R1, L2, R2.
Press SELECT + START simultaneously for 3 seconds green LED turns on.
Press the button that you wish to relocate LED starts flashing.
Press the new button function LED turns off relocation is complete.
Repeat the above steps to relocate further control buttons.
Once powered off, all settings will be erased.
Make sure that the button relocations are deleted before changing to a different driving game, otherwise the
controls may not match the new game.
Clear Button Relocation
Press SELECT + START simultaneously for 3 seconds green LED turns on.
Press the button to delete the relocation on LED starts blinking.
Re-press the button LED turns off deletion is complete.
Repeat the above steps to clear any other button relocations.
Restore factory defaults
Press SELECT + START simultaneously for 3 seconds green LED turns on.
Press and hold the START key until the LED turns off.
-All button functions have been restores to the factory defaults.
To Next Page
Loading...
