3
Important Safeguards
Functions at ambient temperature between 5°C and 40°C
It is recommended to have your Trusti Pasteur temperature calibrated annually.
To protect against electrical shock, do not immerse power cord or plug in liquid.
Unplug the appliance from any electrical outlet when not in use and before cleaning.
Allow the appliance to cool before putting in or taking out any cleanable parts.
Do not use any attachment or accessories not recommended by the supplier.
Do not use this appliance for any purpose other than its intended use.
Do not use this appliance if it has been dropped or appears to be damaged or has a damaged cord or plug.
Do not attempt to operate the appliance with a water level below the MIN (minimum) line.
Take care not to overfill the water bath above the MAX (maximum) water line; allow sufficient room to accommodate the volume of Trusti Bags when added to
water bath. If water level rises above the MAX water line the PCB may be damaged.
Take care when removing the appliance when it is hot, as hot water will collect on the inside of the appliance while working.
To disconnect, touch the Start/Stop button to turn off the appliance, then remove the plug from the wall outlet.
Ensure the water in the Trusti Tub is at a suitable temperature before emptying. Temperatures above 50°C can scald. To empty simply unscrew the plug on one
end of the tub.
Please be careful when removing Trusti Colostrum bags from the water as they can be hot to the touch.
Connect to properly ground (earthed) electrical outlets only and correct stable voltage.
Only use the heating unit in water, no other liquids. Always use clean water to operate with no particles or residues.
Choose a secure location to operate your Trusti Pasteur.
Do not use outdoors.
Do not use near a hot gas or electric burner.
Do not let cord touch hot surfaces.
When the Trusti Pasteur is not in use we recommend to remove the heating unit from the water and allow to dry for storing.
When in use around children and pets, close supervision by an adult is necessary and the appliance should be kept out of their reach.
A.
B.
C.
D.
E.
Display screen
MAX water level
MIN water level
Water outlet
Power connection
F.
G.
H.
I.
Fixing clip
Side water inlet vents
Removable cover
Bottom water inlet vents
f
g
h
i
j
Time setting button
In use symbol
Increase time or temperature button
Decrease time or temperature button
On/Off/Start/Stop button
Circulator Parts
Disclaimer: Antahi Innovations will not be liable for any loss or harm caused to any animal, any indirect, special or consequential loss or damage (whether for loss of profit or
otherwise), costs, expenses or other claims arising out of or in connection with the use of this product.
These are the possible error codes and their meaning.
EO4: Water in the tub/container below the minimum water level of machine, E04 will show on the displayer. top up water above minimum water level, E04 will
all-clear
E08: NTC (temperature sensor) loosening or damage will cause PCB short circuit, this can be caused by water level too high or excessively fluctuating voltage.
E09: Hardware failures, seldom occur. This can be caused by water level too high or excessively fluctuating voltage.
1)
2)
3)
Error Codes:
In the event that the guidelines are not followed the warranty will be void.
Warranty:
a
b
c
d
e
Temperature display
Time display
Symbol for centigrade (if selected)
Symbol for Fahrenheit (if selected)
Temperature setting button
To Previous Page
Loading...