UK-HM35-REV.00 (0218)
Hydromist 35 User Guide
THIS USER GUIDE SHOULD ALWAYS BE USED IN CONJUNCTION WITH THE USER MANUAL
Fill the fresh water solution tank
with mixed water and approved
cleaning chemical according to the
chemical manufacturer’s
instructions.
Press and hold the solution switch
to apply the cleaning solution,
whilst pulling the machine slowly
backwards to clean the carpet.
Stop spraying the cleaning solution
about 30cm before the end of the
cleaning pass to ensure all
solution is vacuumed up.
Wheel the machine forward and
repeat, slightly overlapping the
previous pass. Do not clean any area
more than twice, or overwetting
could result in carpets shrinking.
Fully unwind the supply cord and
plug in to a convenient socket
To lower the floating brush, press
the foot pedal.
Switch on the vacuum motor,
To Next Page
Need help?
General
