TST-770 WSD Full Line Manual-RevA
© 2021 Truck System Technologies and Pressure Systems International Inc. All Rights Reserved Worldwide.
support@TSTtruck.com (770) 889-9102 M-F 9-8pm, Sat 9-2pm EST
Page 30
DUAL WHEEL INSTALLATION -
INTERNAL SENSORS
Always consult with a Certied Safety Consultant prior to any installation
procedures. Read and understand all instructions and procedures before
service to components begins.
Recommended installation orientation for Internal Sensor TPMS-equipped Dual
Wheel Vehicles
1. Please review the following instructions to ensure proper orientation of internal
TPMS Sensors using the 180º valve stem orientation method. See Figure 1.
Figure 1: 180º valve stem orientation for dual wheel vehicles.
INSIDE
TIRE
OUTSIDE
TIRE
INSIDE
WHEEL
VA LVE
STEM
OUTSIDE
WHEEL
VA LVE
STEM
NOTE: Dual Wheel Equipped Vehicles MUST be mounted
with valve stems oriented 180º from each other to allow
pairing of internal TPMS Sensors.
Back To TABLE OF CONTENTS
To Next Page
Loading...