TTC FIREBERD 6000 - Part 2 - Performing the Test

W Part 2 - Pehrming the Test
1
Press RBSIAXT to dear alvms and begin the test. Verify that
A. FlREBERD 6000's PATlgRN SYNC LED is illuminated (indicating a signal is present).
B. RREBERD 6000's FRM SYNC LETl is illuminaled (if PBM SYNC is not illuminated, go back to Step Za and decl
the appropriate frame formal).
I Table 1 -Analysis Results
T-CARRIER FPRES
PPSFS
FBPVS
F
SLP S
P CRC E
F SI GRC
F U) CRC
FMDCRC
F MH CRC
F
HI CRC
FSVCRC
FHSCRC
PRM TIM
PAY SRC
Par-End
Fme Error Seconds
Far-End Severely Errored Framing Seconds
Far-End BW Seconds
Par-End Controlled Slip Seconds
Far-End CRC Error Events
Fat-End CRC 1 Bin
Far-End CRC 2 to 5 Bin
&-End CRC 6 to 10 Bin
Par-EndCRC 11 to 100Bin
Far-End CRC 101 to 319 Bii
Far-End CRC 320 to 333 Bin
Far-End Severely High CRC Bin
Far-End Performance Report Seconds
Far-End F'ayioad Sourcehwpback
Table 2 is a list ofNIBWACB STAl'USLBDs. Wkn Wbenminatedtnch of tk status LhDs mean tk foUowing:
I
Table 2 - Interface Status LEDs
Illuminates when BBZS coding is being received.
Illuminates when a Yellow Alarm is detected.
Illuminates when an Excess Zms Alvm is detected.
TTC Technical Support d
1-800-638-2049
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com