OPERATION
1) HOW TO START YOUR HEAT PUMP
The heat pump starts as soon as the water temperature falls below the preset temperature for the
pool or the spa. Temperature can be set using the UP and DOWN keys.
2) MANUAL ACTIVATION OF SWIMMING POOL MODE
Press and hold set key (3 times) until P-S is displayed.
Press down key until POL el displayed. Note: The heat pump is always in pool mode from
factory
3) HOW TO CHOOSE THE TEMPERATURE MEASURING UNITS
Press set key (5 times) until F-C is displayed.
Press up key for Fahrenheit
Press down key for Celsius
4) MANUAL ACTIVATION FOR SPA MODE
Press set key (3 times)
Press up key until P-S is displayed.
Press up key until Spa is displayed
5) HOW TO TURN OFF YOUR HEAT PUMP
Press the DOWN key until the regulator displays OFF (pool or spa)
Note: regulator can be used to determine filtration time on a daily basis.
IMPORTANT: Use this function ONLY if there is no external timer. Filter timer wiring should be
connected to regulator SF-501. The regulator will control the number of daily operating hours of the
filtration pump.
To activate this option, press and hold the SET key until dEL is displayed. Then press SET twice: FIL
will appear on screen. Press the UP key ( 4times) until FIL is displayed. Use the UP key to choose
between OFF, 2 to 23 hours a day or ON for continuous operation.
To turn off the water filtration system, press the DOWN key until the regulator displays OFF.
WHEN THIS FUNCTION IS USED, FILTRATION SYSTEM OPERATION WILL BE DIVIDED
INTO 6 EQUAL TIME PERIODS A DAY. FILTRATION PUMP WILL TURN ON OR SHUT
OFF DEPENDING ON THE AMOUNT OF HOURS CHOSEN AND THE WATER
TEMPERATURE. IF DESIRED TEMPERATURE HAS NOT BEEN REACHED, HEATING
TIME WILL BE EXTENDED.
To Next Page
Loading...