EN
macOS Users
The tuff nano is pre-fromatted for macOS and ready to use.
Windows Users
You will need to re-fromat the tuff nano for Windows.
Follow the steps below to re-format your tuff nano.
Warning
Re-formatting the tuff nano will erase all data on the hard drive. Back-up
your files before re-formatting. Only proceed if you have backed-up.
1. Connect the tuff nano to your Windows computer with the appropriate
cable.
2. Open Disk Management (Control Panel - Administrative Tools - Computer
Management - Disk Management).
3. Find the tuff nano that you want to format in the list of drives. Right click
on the “Disk Number” and select “Properties”.
4. In Disk Management, right click on the partition that was previously
formatted for Mac and select “Delete Volume…”.
5. On the pop-up window click “YES” to delete the Mac partition.
6. When the disk comes online, right click on the “Unallocated” area and
select “New Simple Volume”.
7. The “New Simple Volume Wizard” pop-up window will appear.
Follow the simple on-screen instructions to finish formatting your tuff nano.
8. The tuff nano will mount on your Windows computer.
Note: USB-C and Thunderbolt™ 3 users must use the supplied USB-C cable,
a certified USB-C cable (10Gb/s,) or a Passive Thunderbolt™ 3 cable. Need
help setting up your tuff nano? Email support@caldigit.com.
To Next Page
Loading...