126 127
Accessories
(1) Replacement cable 7092.300 1.20 m (47.2 in.) for all Turbelle
®
controllers.
(2) Y-adapter cable 7090.300 Moonlight 7097.050 or third additional pump.
The Y-adapter cable expands a single pump output of a Multicontroller 7097 by two outputs. Through this, it is possible
that two Turbelle
®
pumps can be connected to a single socket and controlled parallel. This allows a connection of up
to six pumps to a single Multicontroller 7097 with one Y-adapter cable, and up to eight pumps with two Y-adapters.
(3) Photo diode 7097.050
The Moonlight with photodiode 7097.050 offers a simplied moon-phase of 29 days. For this, a special LED is located
in the photodiode which is positioned above the water surface. The moon-phase is programmed to reproduce the
lunar cycle from the full moon to the new moon. This cycle can be aligned to the natural moon-phase by inserting the
Moonlight with photodiode 7097.050 on a full moon, which will then reset the phase. The Moonlight is only illuminated
when the photodiode receives very little or no light. It is therefore adapted to the light cycle of the aquarium.
(4) Switched Socket Outlet 7097.120
The special switching socket for the Multicontroller 7097 is an option used for the on/off switching of further aquarium
lights on and turn off. The setting of the microcontroller is performed in the eld “Switched socket outlet“, 230 V max.,
1800 W (115 V / 900 W).
To Next Page
Loading...
