Tuscany CS812LP - Side Burner Assembly

To Next Page

To Previous Page

Grill Assembly

Fig. 4

Fig. 5

Fig. 6

Fig. 7

Fig. 8

SIDE BURNER PARTS ASSEMBLY

1. Remove side burner valve assembly from

packaging. Feed the valve assembly through the

large cut out in the side of the cart. (See Fig. 4)

2. Loosen the four hex head bolts on the side of the

grill by approximately 1/4". (See Fig. 5)

3. Attach the side burner by inserting the four bolt

heads into the holes on the side burner. (See Fig. 6)

Tighten the four bolts to secure the side burner (See

Fig. 3 on page 6)

4. Slide the side burner valve stem through the center

hole in the front of the shelf. (See Fig. 7)

5. Insert one valve screw through the bezel and in to

the side burner valve and tighten. Next, install the

second valve screw through the bezel and tighten.

Make sure the bezel is installed with the "OFF"

position facing up. (See Fig. 8)

Install control knob, making sure to line up the at

side of the valve stem with the at side of the knob

stem.

Bolts

Holes

Bolts

Side burner valve

"OFF" on the bezel

vavle stem