Need help?Do you have a question about the Tuuci ocean master MAX Series and is the answer not in the manual?
General| Brand | Tuuci |
|---|---|
| Model | ocean master MAX Series |
| Category | Patio Furniture |
| Language | English |
Remove all packaging from the umbrella, including inside the umbrella.
Pull pin to unlock and ensure the cam lock handle is open.
Slide beauty cover over mast and insert mast into the security stem.
Push cam lock handle until it engages and lock with pin.
Gently separate each rib from the center hub approximately 10 inches.
Lift cart lever to release tension and unlock canopy frame.
Ensure gear lock button is in top/unlock position before turning crank.
Insert crank handle and rotate clockwise to open the umbrella.
Engage gear lock and store crank handle safely after full deployment.
Make sure the cart lever is unlocked to allow angle adjustment.
Move cart handle to desired position and lock with cart lever down.
Lift cart lever to release tension and unlock.
Ensure gear lock button is in top/unlock position before turning crank.
Insert crank handle and rotate counterclockwise until it stops.
Move the cart to the bottom position.
Collapse frame against mast and lock the closed position by setting cart lever down.
Tie back the umbrella canopy when it is not in use.
Connect the electrical cord to the power outlet.
Tap finial to power on/off, touch and hold for dimming control.
Details on power supply, input voltage, input current, output voltage, and output power.
Rinse the umbrella with fresh water once a week.
Inspect for loose screws and broken components; tighten or replace promptly.
Close umbrella in wind conditions exceeding 25 MPH to prevent damage.
Clean bases with soap and water; avoid rolling concrete bases on their side.
Clean canopy with mild soap and lukewarm water using a soft brush.
To Next Page
