C2-2855 FAQ
Version 1.0 Page 1 of 5
C2-2855 Frequently Asked Questions
Which input source can I genlock to?
You can genlock to any available input source.
If I’m using any of HDMI, YC, CV or PC/HD why can’t I select any of these for another layer?
Due to the hardware architecture it is not possible to use 2 of these I/O connections at the same
time. You can overcome this by using the DVI-U dongles to expand the I/O connectivity.
Does the C2-2855 accept 3G SDI level A and B?
C2-2855 only accepts 3G SDI level A only.
Does C2-2855 work with 8bit or 10bit video?
SDI inputs/outputs are 10bit, all other video inputs/outputs are 8bit (analog, DVI, HDMI, CV, YC.)
Where can I find the latest version of firmware?
Firmware updates can be found by clicking the following link,
http://www.tvone.com/tech_support_firmware.shtml
How many still image stores (SIS) can I have on my unit?
You can store up to 5 still image stores on the C2-2855.
What is DVI-U? Which video types can I use?
DVI-U is an interface that is fully DVI-I compliant and offers analog (YC, CV, RGB & YPbPr) & HDMI
connectivity via low cost dongles which are available from tvONE.
When I power down my unit and turn it back on I seem to lose my settings? Is there any way around
this?
Yes – once you’ve made you have changed your settings, push and hold the OK button in until the
unit beeps, and you will have a message appear saying…(settings saved). This is classed as a power
on preset.
To Next Page
Need help?
General
