To Next PageTo Next Page
Need help?Do you have a question about the Twisted Hobbys Veloxity and is the answer not in the manual?
General| Brand | Twisted Hobbys |
|---|---|
| Model | Veloxity |
| Category | Toy |
| Language | English |
Read instructions, check components, and be aware of environmental factors.
Address radio interference issues and ensure adult supervision for young pilots.
R/C aircraft requires understanding of manual, open area flying, and potential pilot assistance.
Recommend building surface and types of glue for joints like foam-to-foam and plastic/carbon.
Use "Tack Up" method to join wings to fuselage, ensuring even glue coats and pressure.
Test fit motor mount, carbon stiffeners, and landing gear platform for proper alignment.
Attach motor mount and install top side rectangles by applying glue and pressing them into place.
Install bottom rectangles and LG platform, securing with glue and weights for drying.
Install aileron control rods, aligning servo horns and securing servos with glue.
Install elevator and rudder control rods, ensuring proper alignment and centering.
Install motor and position electronics to achieve the correct Center of Gravity (CG) point.
Secure components, strengthen hinges, balance props, and check control directions/throws.
The Center of Gravity (CG) is located 275mm from the nose of the aircraft.
Position electronics to achieve the indicated CG point for optimal flight performance.
Control throws for Extreme & 3D: Ailerons +/-40°, Rudder +/-45°, Elevator +/-50°.
Control throws for Beginner & Sport: Ailerons +/-20°, Rudder +/-20°, Elevator +/-20°.
Perform checks on motor, controls, batteries, radio, and range before flying.
