Tylo Sense Combi-U 7 Installation & User Guide

7
7. Connect the light cable (if relevant) (7), see Figure 11, to the
terminal () according to the wiring diagram Figure 19.
8. Close the cover and tighten the screws (see Figure 10).
9. Hang the heater on the bracket (see Figure 12).
Figure 12: Hang the heater up.
10. Fit the spacers between heater and wall (to prevent the heat-
er from being lifted o󰀨 ) (see Figure 13).
Fig 13: Fit spacers
11. Fit the cover for the water reservoir, herb grille and fragrance
holder/air humidi er (see Figure 14).
Fig 14: Fitting the cover for the water reservoir, herb grille and
fragrance holder/air humidifi er
12. Install the sensor on the wall see Fig 15 and 16. The therm-
istor wire may also be passed through the wall see Fig 17
and 1. Seal any holes in the wall behind the sensor. The
thermistor wire may be extended outside the sauna using low
voltage wire (2-lead).
Fig 16: Installing the humidity- and temperature sensor - Combi
Elite. The cable inside the sauna must be heat resistant.
Combi Elite

Tylo Sense Combi-U 7 Specifications

General

Brand	Tylo
Model	Sense Combi-U 7
Category	Electric Heater
Language	English