PTO GEAR SELECTION LEVER
Your tractor is equipped with 3 speeds PTO to suit range of applications and conditions.
PTO : 1
st
:550 rpm 2
nd
:727 rpm 3
rd
:1,013 rpm
Always use the clutch when engaging or disengaging the PTO or changing
PTO speed. Let the PTO driven implement come to a complete stop before
changing
important
Caution
Do not operate any implement at a high speed than is specified for it.
When making adjustments to the implement stop the engine to avoid serious
injury.
When leaving the tractor stop the engine, and remove the key. Set the parking
brake.
Operating the hydraulics.
The hydraulics are powered with an engine driven hydraulic pump and controlled with a position
control lever mounted beside the driver.
40
Position control
▶ implements can be raised and lowered with the
hydraulic position control lever and can be stopped
at any position by stopping the lever.
To ensure a consistent working depth the adjustable
stop can be set to ensure that the implement returns
to the same depth every time.
To raise the implement: Pull the lever back
To lower the implement: Push the lever forward.
Warning
After finishing the work, always lower the implement to the ground and switch
off the engine, Set the parking brake to avoid injuries and accidents .
To Next Page
Loading...
Need help?
General
