■ Adjustment of the Turnbuckle type (If equipped)
To adjust the check chain turn the turnbuckle to lengthen or shorten the chain and tighten the lock nut
when the correct adjustment is achieved.
■ Adjustment of the Telescopic stabilizers type
To adjust the check chain move the Telescopic stabilizer to lengthen or shorten the chain
and Fix the Pin as required distance
The stabilizers are intended for limiting or preventing implement side movement.
►
►►
► ADJUSTMENT OF THE CHECK CHAIN
There should be no clearance (Position A) during implement transport and when working with grades,
rollers mowers, seeders, drills and similar implements.
However, a slight play is necessary (Position B) when working with ploughs, harrows, ditchers,
cultivators.
* Telescopic stabilizers type
* Turnbuckle type
►
►►
► ADJUSTMENT OF THE LIFT ROD
Adjust the length of the lift rod by screwing the Adjusting
Handle (Turnbuckle) in or out. Adjust the length of the lift rod
as necessary to set the implement in its working position parallel
to the ground.
►
►►
► ADJUSTMENT OF THE TOP LINK
Lengthening or shortening the top link will change the angle of
the implement. The locating hole of the top link varies with the
type of implement used. The most common locations are the 2
nd
and 3
rd
hole from the top.
To Next Page
Loading...
