TYM T330 - Operating Safety Precautions; ROPS and Seat Belt Usage; Avoiding Tipping and Safe Parking; Keeping Riders Off the Tractor

USE OF ROPS AND SEAT BELT
The Roll Over Protective Structure(ROPS) has been certified to industry
and/or government standards. Any damage or alternation to the ROPS,
mounting hard-ware, or seat belt voids the certification and will reduce
or eliminate protection for the operator in the event of a roll-over. The
ROPS, mounting hardware, and seat belt should be checked after the
first 100 hours of Tractor and every 500 hours thereafter for any
evidence of damage, wear or cracks. In the event of damage or
alteration, the ROPS must be replaced prior to further operation of the
Tractor.
The seat belt must be worn during machine operation when the machine
is equipped with a certified ROPS.
Failure to do so will reduce or eliminate protection for the operator in
the event of a roll over.
PRECAUTION TO AVOID TIPPING
Do not drive where the Tractor could slip or tip.
Stay alert for holes and rocks in the terrain, and other hidden hazards.
Slow down before you make a sharp turn.
Driving forward out of a ditch or mired condition could cause Tractor to
tip over backward. Back out of these situations if possible
tip over backward. Back out of these situations if possible
PARK TRACTOR SAFELY
Before working on the Tractor ;
Lower all equipment to the ground.
Stop the engine and remove the key
KEEP RIDERS OFF TRACTOR
Do not allow riders on the Tractor.
Riders on Tractor are subject to injury such as being stuck by foreign
objects and being thrown off of the Tractor
13