TYM T330 - Track Adjustment

▶
▶▶
▶ USE OF THE RETENTION SPRING
When not using implements on the three point
linkage use the rubber as shown to prevent tire
damage.
Only use drawbar to tow and keep the 3 point linkage in raised position when
towing with the drawbar.
Position can create unbalance causing the Tractor to roll-over & Result the death
or serious injury.
Danger
▶
▶▶
▶ MOUNTING IMPLEMENT
If the PTO is used, remove the safety cover off the PTO shaft.
Adjust the yoke rod on the lower links to suit the implement in use.
Attach the left lower link, then attach the right lower link using the
adjusting handle on the leveling box if required.
Attach the top link.
Attach the PTO shaft to the tractor if used, making sure that it is
locked in place.
Adjust the check chains to suit the implement and tighten the
45
Do not attach a PTO shaft with the engine running and ensure all safety shields are
in place.
Adjust the check chains to suit the implement and tighten the
locknuts.
To remove an implement reverses the procedure.
Caution