BLEEDING THE FUEL SYSTEM
1) Fuel filter cock 「 ON 」
2) Open the cock on the fuel injection pump
3) Fill the tank with fuel and turn the ignition key to on.
5) Close the fuel injection pump cock.
6) The bleeding of the system is now finished.
CHANGING THE OILS IN THE TRACTOR
Always use quality oils as engine or transmission oil (refer to the page 60)
Refer to the table on page 57, 58 and 59 for the change frequency.
▶
▶▶
▶ Changing engine oil.
Park tractor on level surface, shut-off engine
Remove sump plug & drain oil.
Replace and check the sump plug and refill the engine with oil
to the correct level on the dipstick (approx 2.38 gal)
The grade of oil to be used will depend on the ambient
temperature.
The tractor is shipped from the factory with 10W/30
For summer use over 77℉ use SAE 30
For temperatures from 32℉-77℉ use SAE20 or 10W/30
For temperatures below 32℉ use SAE 10W
To Next Page
Loading...
Need help?
General
