CHECKING THE WIRING HARNESS AND FUSES
Loose wires make inferior connections and damaged wires can cause short circuits, fires burnt wiring or
reduce efficiency of components.
Replace or repair any faulty wiring or insulation.
If a fuse burns out again after it has been replaced, do not replace it with wire or a high capacity fuse, find
the cause and rectify it or get an auto electrician to do so.
Where insulation is chafed or peeled off, recover the area with a good quality insulation tape. Where
wiring comes out of it’s fitting replace it correctly with the standard fitting.
important
Incorrect wiring or fuses can cause fires to both the tractor and surrounding area so get
the dealer to check it annually.
Likewise fuel pipes and wiring age with use.
Ask your dealer to check it at least once every 2 years and replace as required
▶
▶▶
▶ MAIN FUSES
The wiring harness is equipped with 3 main fusible links who’s
function is to preserve the wiring.
However when a main fuse blows the entire circuit is dead.
Always check the reason & rectify before replacing the fuse of
72
▶ REPLACING FUSES
The circuit has 8 blade type fuses in its wiring circuit
(See diagram on page 86)
When a fuse has blown replace it with one of the same value.
Using a large capacity fuse or wire burn out the wiring system.
Use fuse tongs to replace fuses
To indicate that the fuse is blown it will be discolored.
important
Always check the reason for a blown fuse otherwise the new fuse is also likely to blow.
NEVER EVER USE WIRE in place of correct grade fuse.
SERVICE PRIOR TO DAILY AND SHORT TERMS STORAGE.
Wash the tractor and keep it clean.
Fill the tank to avoid condensation and rust.
Lower any attached implement to the ground before parking the tractor.
For long-term storage consult your dealer
To Next Page
Loading...
Need help?
General
