If voltages on ‘Power Out’ cable JP1 connection are NOT correct? Then disconnect ‘Power
Out’ cable from XT A00381 Termination Board JP1 (as per below) and measure voltages at
‘Power Out’ cable direct. Are Voltages Ok?
24v (Blue Cable) = 24-26v DC 12v (Brown Cable) = 12–13.75v DC
5v (Pink cable) = 5v
If voltages are NOT correct then possible fault on ‘Power Out’ cable or connector
If voltages are ok, then possible problem with XT A00381 Termination Board or the system
Network that is connected to it.
To Next Page
Loading...
