TYVASO DPI - Page 8

6
Place Inhaler on
Flat Surface
Place the inhaler on a flat surface
(see Figure M).
Figure O Figure P
Figure N
Figure M
POINTED END
ALIGNS
Step 6: Load a cartridge
Place Cartridge in Inhaler
• Hold the cartridge with the cup facing down (see Figure O).
• Line up the cartridge with the opening in the inhaler.
The pointed end of the cartridge should line up with the pointed end
in the inhaler (see Figure P).
• Place the cartridge into the inhaler so that it lies flat.
Preparing to Inhale TYVASO DPI (continued)
Open Inhaler
Open the inhaler by lifting the
mouthpiece to an upright (vertical)
position (see Figure N).
Important: If the cartridge came
from a strip stored in the refrigerator
(or if you stored the inhaler in the
refrigerator), leave the cartridge and
inhaler at room temperature for 10
minutes to remove condensation.