Titan 20 User Manual
- Repeat the check for reverse driving as well.
■ Air pressure check – The wheel air pressure should be 2.5 bar / 35 psi.
Keeping the air pressure at the proper level will lengthen the tire lifespan,
and will increase the travel radius per battery charging.
Semi-annual Checks
■ Use lubricating liquid (WD40 or similar) on the following areas:
- Tiller locking pin and its seating
- Chassis locking pin
- Seat folding hinges
■ Check the wear and tear on the wheels.
Annual Checks
■ We recommend that an authorized technician perform the annual check.
The technician will check all connections, the electric motor status and
the battery condition.
■ Fuse replacement should be done only by a service representative. Fuses
are located in the following locations.
- 60A Battery pack fuse – One in each battery pack
- 5Ax2 electrical circuit fuse – Under the controller lid
Periodic Checks
■ Clean the scooter with a moist towel only. Do not wash the scooter with a
hose or direct contact with water.
■ Keep dirt out of the wheel axes, including lint, hair, sand and carpet fibers.
■ Check the wheels. If the wheels are worn, replace them immediately.
If you find a fault, contact your service representative. Do not
try to fix problems on your own. Repairs performed by people
other than authorized representatives may cause harm to the
people and or the scooter, and will void the warranty.
Note:
To Next Page
Loading...
