u-blox ANTARIS 4 - Page 140


your position is our focus
7.2.1.1 Receiver Output Messages

Figure 112: Message Display of an U-center output message
 N on an  message ables  periodic message update if the
protocol ive.Thisfeatureiscu rtedfortheUBXprotocol.
In gescanbeeditedand Srec fro eView.Itisalsopossibletopoll
the
c gs.
ote Double-clicking
communication
 output
isact
en or disables the
rrentlyonlysuppo
7.2.1.2 Receiver Input Messages
putmessa senttotheGP eiver mtheMessag
urrentreceiversettin

Figure 113: Message Display of a u-center input message
 Note u-center performs some range checks on input messages. If an input value exceeds the permitted
range,u-center willhighlightthefieldin redbut itisstillpossible tosend thevalue tothe receiver.
However,thereceiverislikelytorejectsuchamessage.
Last Update
Timeinseconds
sincelastupdate.
Message Content
Selected Message
Blueshadedifmes-
romthe
sagehasbeen
receivedf
GPSrecently
otherwisegrey.
Hex Dump
Last Update
Timeinseconds
sincelastupdate
(sendingorpolling)

Selected Message
Blueshadedifmes-
sagehasbeen
grey.
receivedfromthe
GPSrecently
otherwise
Hex Dump
Message Content
Message Tree
sages
tlybeen
Blackmes
haverecen
updated;grey
messageshavenot
beenupdated.
GPSModules-SystemIntegrationManual(SIM)(incl.ReferenceDesign) PCSupportTools
GPS.G4-MS4-05007-A1
  Page 140