U-Line 3000 SERIES - Safety and Warning Information; Safety Alert Definitions

u-line.com 3
4. Remove (2) hinge covers. Pushing top tab upward and bottom
tab downward, slide the cover off the hinge.
Figure 4 Hinge Cover Removal
Door Removal:
1. Loosen, but do not remove, the slotted hinge screw with a
T-25 Torx. (Slotted hinge screw is located closest to the unit
exterior.) Repeat for other hinge.
Figure 5 Removing Hinge Screws
2. Remove the non-slotted screw completely. (The non-slotted
screw is located closest to the unit interior.) Repeat for other
hinge.
3. Slide door so slotted hinges disengage.
CAUTION
!
To avoid damage to the unit, place the door near the unit.
The door is connected to the unit with a cord. Use care
when moving.
4. Place door by unit.
5. Completely remove (2) previously loosened slotted screws.
A
B
C
Bare Hinge
Hinge Screws (2)