SCREENING CALLS
15
Design
■
Features
■
Performance
When I turn the unit on, all I get is water fill - CLR2060 Model Only
• Check to be sure switch is in ice mode.
•Once the unit is turned on, there will be a three minute water fill. This will assure that a fresh batch of
water has filled the trough. If water flows more than three minutes a service call will be required.
My ice does not come out in a perfect cube shape - CLR2060 Model Only
• The manner in which the ice is made causes a small hole or “dimple” to appear on the front or top of
the cube. Increasing or decreasing the time of the freeze cycle will adjust the size of the dimple. A
service company will need to make this adjustment.
The cubes do not fall into bin as individual cubes - CLR2060 Model Only
• Normal - You can use the scoop to break apart.
Not enough ice is stored in the bin - CLR2060 Model Only
• Check the level of the unit.
CUSTOMER
COMPLAINT
CUSTOMER
COMPLAINT
CUSTOMER
COMPLAINT
CUSTOMER
COMPLAINT
To Next Page
Loading...
