PAGE 11 OF 36 0319 IH-5836
SETUP MENU CONTINUED
5. Press the ZERO key to enter the sub menu.
6. Press the TARE key until the desired setting is
shown on the display.
• Cont – Continuously sends data to printer.
•
St 1 – Sends data one time to printer when
indicator is stable.
• St C – Sends data continuously to printer when
indicator is stable.
• Pr1 – Sends data one time to printer when the
ACC/TTL Print key
is pressed.
• Pr2 – Performs accumulation and sends data one
time to printer when the ACC/TTL Print key
is pressed.
• Auto – Performs auto accumulation and auto print
when indicator is stable and returns to 0.
7. Press the ZERO key
to select the new setting.
8. Press the UNIT key
twice to exit the menu.
BAUD RATE
Baud rate is the RS-232 transmission speed. If using a
printer, both the printer and the scale must be set to the
same baud rate. At startup, the baud rate is set at 9,600.
Enter this menu to change the baud rate setting
1. Turn on the scale and press the PCS key
during
the self-test. Pn will be shown on the display.
2. Press the G/N key
, then the UNIT key and
then the TARE key
. Po CHF will be shown on the
display.
3. Press the TARE key
until P1 com is shown on the
display.
4. Press the ZERO key
to enter the menu. Mode
will be shown on the display.
5. Press the TARE key
until Baud is shown on the
display.
6. Press the ZERO key
to enter the sub menu.
7. Press the TARE key
until the desired setting
is shown on the display.
• 600
• 1200
• 2400
• 4800
• 9600
8. Press the ZERO key to select the new setting.
9. Press the UNIT key
twice to exit the menu.
PRINTER SET-UP
Enter this menu to select a printer.
1. Turn on the scale and press the PCS key
during
the self-test. Pn will be shown on the display.
2. Press the G/N key, then the UNIT key
and then
the TARE key
. Po CHF will be shown on the
display.
3. Press the TARE key
until P1 com is shown on the
display.
4. Press the ZERO key
to enter the menu. Mode
will be shown on the display.
5. Press the TARE key
until Ptype is shown on the
display.
6. Press the ZERO key
to enter the sub menu.
7. Press the TARE key
until the desired setting is
shown on the display.
• tPUP – Ticket printer
• LP-50 – Label Printer
8. Press the ZERO key
to select the new setting.
9. Press the UNIT key
twice to exit the menu.
To Next Page
Loading...
