U-Line H-9180 - Assembly Instructions

PAGE 2 OF 18 1022 IH-9179
NOTE: Count and inspect all pieces before
disposing of any carton or packing materials.
CAUTION! Adjustable frame is heavy and
care should be used when moving it during
assembly.
1. Place adjustable frame with lifting columns on a
smooth, non-marring surface to prevent scratching.
NOTE: Lifting columns are pre-installed to
adjustable frame and are folded down toward
center of adjustable frame for shipping.
2. Unfold the lifting columns to an upright position.
(See Figure 1)
3. Insert top support bracket (4) into outside of
adjustable frame (2). Repeat this step on the
opposite side. (See Figure 2)
NOTE: Steel lip with three holes on top support
bracket should be facing down.
4. Insert two M6 x 33 mm machine screws (9) into holes on
end of adjustable frame to connect adjustable frame
with lifting columns and top support bracket . Lightly
tighten using 5 mm hex wrench. Then lightly tighten
two pre-installed M6 x 33 mm machine screws (9)
to secure lifting column. Repeat this step on the
opposite side. (See Figure 3)
NOTE: To prevent alignment issues during this
step, do not tighten completely until all four
machine screws are inserted.
5. Attach foot (3) to lifting column using four M6 x 15 mm
machine screws (10). Tighten using 4 mm hex wrench.
(See Figure 4)
ASSEMBLY
Figure 1
Lifting
Column
2
Figure 2
4
2
Figure 3
9
Figure 4
10
3
Lifting
Column