PAGE 2 OF 8 0221 IH-9234
ASSEMBLY
IMPORTANT!
Before setting up tent, contact
Diggers Hotline (8-1-1) or a local authority to
verify that it is safe to set up tent in desired
location. Be aware of weather conditions, and
always evacuate tent during periods of high
winds or lightning.
1. Ensure all parts are present before assembly. Lay
frame parts on ground in approximate locations
they will be when frame is assembled. (See Figure 1)
2. Place frame pins in 8-way crown.
a. Each protrusion on crown has two holes. The
alignment hole is closer to the center; the
placement hole is further down the protrusion.
(See Figure 2)
b. Place a pin in every other alignment hole. This
pin prevents the rafter from moving too far onto
crown. (See Figure 3)
3. Align four hip rafters (HR) with 8-way crown.
(See Figure 4)
a. Slide tubing onto protrusion until it meets pin.
(See Figure 5)
Figure 1
LG LG
EV EV
HRHR
FR
EV EV
HRFR EVHREV
FR
EV
EV
FR
5'
7'
20'
Figure 2
Alignment Hole
8-Way Crown
Placement Hole
Figure 4
HR
HR
HR
HR
Alignment
Hole
Figure 3
Pin
Figure 5
To Next Page
Loading...